- West 6010 Manual Diagram
- West 6010 Manual Pdf
- West 6010 Manual
- West 6010 Manual Transmission
- West 6010 Manual Download
- 6010 Manual Us Navy
West Control Solutions 8700+ User Manual. 6 messages and error indications. West Control Solutions Equipment. TRICARE Policy Manual 6010.60-M, April 2015. These manuals are applicable to the East and West Regional Managed Care Support Contracts awarded on or after 07/21.
1
/
4
-DIN,
1
/
8
-DIN &
1
/
16
- DIN Controllers & Indicators - Product Manual
59305, Issue 7
– March 2014
Powering Up
Page 37
6 Messages and Error Indications
The following displays are shown when an error occurs or a hardware change is detected.
Table 4. Error/Faults conditions
Error/Faults Conditions
Upper display
Lower Display
(where fitted)
1
/
8
DIN Indicator
Units Display
West 6010 Manual Diagram
Configuration & Setup is required.
Seen at first turn on or if hardware
configuration changed.
Press to enter Configuration
Mode,
next press or to enter the
unlock code number,
then press to proceed.
Configuration must be completed
before return to operator mode is
allowed
1
( for 1
second, then
on
Indicators)
Input more than 5% over-range
2
West 6010 Manual Pdf
*
Normal Display
Normal Display
Input more than 5% under-range
3
*
Normal Display
Normal Display
Sensor Break. Break detected in
the input sensor or wiring
*
Normal Display
Normal Display
Auxiliary input over-range
Normal Display
*
n/a
Auxiliary input under-range
Normal Display
*
n/a
Auxiliary Break. Break detected in
the auxiliary input
Normal Display
*
n/a
Option 1 module fault.
**
Option 2 module fault.
**
Option 3 module fault.
**
Option A module fault.
**
Option B module fault.
* Note
Input sensor and Auxiliary over/under-range or break indications will be seen wherever
these values would normally be displayed.
** Note
Option module number follows error legend on
1
/
16
DIN Indicators (e.g. )
1
West 6010 Manual
This feature does not guarantee correct configuration. It only helps to ensure that the unit will be configured
before use. Use of set-up mode is not enforced but may be essential for the users application.
2
If the PV display exceeds
before 5% over-range is reached, an over-range indication is given.
3
Indicators will allow up to 10% under-range on non-zero based Linear ranges. If the PV display is less than
West 6010 Manual Transmission
before the % under-range is reached, an under-range indication is given.